Was looking on the RC group asking about power requirements and I found this on a thread when I was browsing. http://www.sparkfun.com/shop/index.php?shop=1&cart=175696&cat=86&

Really neat, 2.50 a square inch for a pbc, I am sure theres probably a "string" atached, then again I could be wrong. Any who just wanted to make you guys aware.

Everyone on this forum who didn't know about this should be thanking you for this link. $2.50 per square inch is CHEAP -- especially with NO minimum order, 2 layers, solder mask and silkscreen on BOTH sides. Wow.

_________________
Thanks for playing.
-- Lord Steve

Sorry for being idle for so long, work and school seem monopolize on my free time these days. I'm going to give this board house a go, since I just finshed up routing and FPGA board(took a while but it should work although its 2 layer). Now for a 6502 board that wouldent be much of a problem given that you can put as much or as little as you want on the board. Only problem I have is the wires and spaceing have to be 8mil miniumum, thats not a problem when working with a Z80 or 65C02 but for a Spartan-3E, eh there can be trouble.