6502.org

Hello there:

Do you know of any reliable supplier of 27C128 EPROMS?
I will settle for pulls (used ones), as long as they are not defective.
I used to buy it from Futurlec (Australia), but having problem getting it now.
There are a few suppliers who say they have it, but don't.
Then there are companies who send you pulls (used) 27C128, but they are defective and cannot be programmed.
One of these companies is Jameco out of California.
Of course, many pulls are fine (not from Jameco), so I am looking for supplier of these.
Any suggestions will be appreciated.
Thanks!

the 16K 27128 are sometimes hard to find so in the past I have programmed the 16K image into the lower and upper halves of a 32K 27256 which are much easier to find and this will drop into the 27128 socket no problem