My own design.

I had a bunch of them made up at one time with the intention of selling them, but never got around to it. If you want some, PM me and we can work something out. I think they cost me about $10 a piece and I'd be willing to let them go for that. I have about 50 of them and will probably not use up 1/4 of that for myself.

Summary of the specs (again):
> 2 power supplies with LEDs
> Breakouts for DB9F and 3.5mm Stereo jacks
> 2 momentary PB switch breakouts
> 6 LED with resistors
> SIL header/connector area
> DIL/IDC header/connector area
> 2 SVG/TIL header/connector areas (for sensor/actuator 'bricks')
> .2" (5.08mm) spacing connector/terminal area
> 1.6mm FR4 board
> 1oz copper
> Tinned pads and solder mask
> All holes are plated through
> Power rails are double sided
> Power rails split into two power zones
> Component zones have 6x5 hole strips to accommodate a wide variety of DIP or other packages.

_________________
Bill

I see, I thought the second photo was the bottom of the board. So, it's just like a breadboard -- that you solder on.

Like this one, but double-sided and not incompatible with wide DIPs.

Yes, exactly - with the additional 'features'.

_________________
Bill