6502.org Forum  Projects  Code  Documents  Tools  Forum
It is currently Fri Mar 29, 2024 2:01 pm

All times are UTC




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: VRC7 input pin circuit
PostPosted: Tue Apr 14, 2020 3:49 pm 
Offline

Joined: Mon Mar 25, 2019 4:28 pm
Posts: 20
Not sure if this is the right place to ask this.

When I was looking at a die shot of the VRC7 chip, I saw these circuits on most of the input pins. I wanted to verify that I've understood the circuit correctly, since to me the configuration of transistors seem odd. The link also has a Visual6502 style coloration as well as a transistor circuit. The lower metal strip is input and the upper metal strip is output. The outputs always go to a gate of a transistor (except for /debug pin that has a power source on the output line to force the line high). The circuit most likely is a ESD/over-voltage protection circuit.

Do you think that the configuration I came up with is correct or not?


Top
 Profile  
Reply with quote  
PostPosted: Tue Apr 14, 2020 4:29 pm 
Offline
User avatar

Joined: Thu Dec 11, 2008 1:28 pm
Posts: 10760
Location: England
I'm not sure the fat poly on the right is actually a transistor: I don't see edges where the active crosses the poly. This structure isn't obvious to me - and nor is the whole assembly!

Are you sure the rail that you've coloured green is the ground rail?


Top
 Profile  
Reply with quote  
PostPosted: Tue Apr 14, 2020 4:58 pm 
Offline

Joined: Mon Mar 25, 2019 4:28 pm
Posts: 20
BigEd wrote:
Are you sure the rail that you've coloured green is the ground rail?


Yeah I'm sure of that. I used a logic gate that I could clearly see to figure which rail was power and which ground and then just followed them and colored over them to map them out.

BigEd wrote:
I'm not sure the fat poly on the right is actually a transistor: I don't see edges where the active crosses the poly.


I too was questioning whether there actually is a transistor. Perhaps it was supposed to be something, but then it was disconnected? The pin should still work without it, even though it doesn't seem to have any protection (although I'm not sure if it even needs any).


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 8 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: