6502.org Forum Projects Code Documents Tools Forum
It is currently Sun Nov 24, 2024 4:25 am

View unanswered posts | View active topics


Board index » 6502.org Users Forum » General Discussions

All times are UTC




Post new topic Reply to topic  Page 2 of 2
  [ 16 posts ]  Go to page Previous  1, 2
  Previous topic | Next topic 
Author Message
BillO
PostPosted: Wed Apr 18, 2018 9:43 pm 
Offline
User avatar

Joined: Fri Dec 12, 2008 10:40 pm
Posts: 1007
Location: Canada
BigDumbDinosaur wrote:
I'm an old stick in the mud and continue to use my trusty X-Acto knife for trace-cutting. :roll:


I used to, but found the drill route is much, much faster and the results are a lot cleaner and more precise. I used to use the pin vice drill for working with strip boards (have done for years) then not having a new blade for may X-Acto knife I tried the drill on a PCB. I'll never go back to butchering boards with an knife again.

_________________
Bill
Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 2 of 2
  [ 16 posts ]  Go to page Previous  1, 2

Board index » 6502.org Users Forum » General Discussions

All times are UTC


Who is online

Users browsing this forum: No registered users and 12 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
6502.org is an ongoing project by Mike Naberezny and contributors.